1959 Willys Ford 302

admin — Sun, 13 Jun 2010 13:55:04 +0000

This is the first firing of the 302 I built for my 59 willys wagon, it is a 68 galaxy block bored 40 over with a gear driven comp 268 cam, roller tip magnum rockers, summit racing intake, edelbrock 1405 4 barrel carb, shaved c60e casting 289 heads, flat top pistons, 60,000 volt HEI, and some block hugger headers

Duration : 0:0:45

Technorati Tags: 302, barrel, Carb, engine, ford, hot, idle, motor, rev, rod, speed, street, truck, v-8, v8, Vintage, Wagon, willys, windsor

Hot Rodding the Eazy Project (Dad’s Truck)

admin — Thu, 11 Mar 2010 05:43:06 +0000

Took some parts off a engine I had in my shop whose pistons split apart (literally) It had a carburetor from a Jeepster on it, and a intake manifold from the same. A vacuum advance distributor was also installed. On top of all this it has a Kaiser Supersonic head was installed (higher compression).

Since my dad’s truck wasn’t running the best with the stuff it had on it, I decided to take the parts from the other engine and install it on the Eazy Project to get a little better performance.

Took only about 9 hours to swap everything over, that’s including cleaning and watching paint dry.

New points, rotor, cap, and wires were also used. Runs great, but still need to fix a few things with the throttle linkage.

Duration : 0:1:1

Technorati Tags: 134, dad's truck, flathead, go-devil, head, hot, idle, jeep, Kaiser, repair, rod, rodding, run, running, Supersonic, truck

Willys Wagon » idle

1959 Willys Ford 302

Hot Rodding the Eazy Project (Dad’s Truck)