Willys Wagon

Took some parts off a engine I had in my shop whose pistons split apart (literally) It had a carburetor from a Jeepster on it, and a intake manifold from the same. A vacuum advance distributor was also installed. On top of all this it has a Kaiser Supersonic head was installed (higher compression).

Since my dad’s truck wasn’t running the best with the stuff it had on it, I decided to take the parts from the other engine and install it on the Eazy Project to get a little better performance.

Took only about 9 hours to swap everything over, that’s including cleaning and watching paint dry.

New points, rotor, cap, and wires were also used. Runs great, but still need to fix a few things with the throttle linkage.

Duration : 0:1:1

Technorati Tags: 134, dad's truck, flathead, go-devil, head, hot, idle, jeep, Kaiser, repair, rod, rodding, run, running, Supersonic, truck

Posted on March 11th, 2010 under jeepster parts. Tags: 134, dad's truck, flathead, go-devil, head, hot, idle, jeep, Kaiser, repair, rod, rodding, run, running, Supersonic, truck. RSS 2.0 feed. Leave a response, or trackback.